Marantec Comfort 250 Betriebsanleitung PDF herunterladen (Seite 10)

English Page 10

D. Installation

Mount the lintel joining plate

• To protect the pull element, which is integrated in the boom (chain or toothed

drive belt), against unauthorized and forced dismantling from the outside

(break-in), push the red securing sleeve (D) over screw (E) (fig. D.8).

• Then connect the lintel joining plate (A) and the boom end piece (B) with bolt

Unlock the carriage

• Push the red release pin (B) to the stop into the red opening of the carriage

(fig. D.10).

• Pull the cable (A) (fig. D.12).

• The carriage is now unlocked and can be slid freely in the boom and

connected to the door.

• For further information regarding the carriage please look up point 13.

Garage door operator with up-and-over door

• Screw the lintel joining plate (A) together with the boom to the top frame,

lintel or ceiling, so that the upper edge of the door leaf lies approx. 10 mm

below the downward edge of the horizontal boom - measured at the highest

point of the opening course (see as well point 3).

• Put the operator unit onto a trestle or another suitable object until it is fixed

later to the ceiling.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 87 88

Keine Kommentare

Marantec Comfort 250 Betriebsanleitung Seite 10